Suchergebnisse

Hi there, I just tested deepstack+aitool+blueiris for security purposes on all the cameras installed on my DVR. The results are amazing for human detection. After little optimization there are 0 false alarms. Im thinking this can be used in ardumower for obstacle detection using a camera...

Hallo auf der Platine 1.3: Ich bemerkte, dass beim Schieben des Mähers auf seinen Rädern (bei ausgeschalteter Stromversorgung) die LEDs am Mainboard eingeschaltet wurden sollte die Schutzplatine dies verhindern oder ist dies normales Verhalten?

work in progress :) one mow motor eats about ~1.2 amps on load with grass.. might need to replace the driver for 2 motors since its on the limit with both motors running

This is just a tip.. maybe somebody is tired of cables when changing code to arduino and might find this usefull. Current setup: raspberry pi0w connected to arduino. Camera can also be attached to it. This draws way less energy from the battery than a rpi 3b,4. Using...

Is it possible to connect two mow motors on pcb 1.3 ? i read on the documentation to unset jumper jp3 for 2nd mow motor.. thank you

does the current firmware knows to charge/resume operation using rtk gps ? in case the lawn is too big and battery runs out ?

hi there anybody have a broken robomow rc model ? i need the front board one of the coils from of my robomow rc304 is not sending signal anymore (30-40 instead of required 400) anybody measured/replaced these coils on robomow front board ? I have a few 150mH from the ardumower project but i...

is it possible to connect a BMS battery on pcb 1.3 to enable the detection when the battery is charged ? my battery has a separate charging connector to bms and normal + - output

sorry for the noob question im preparing the wires for the imu and im a little confused about the pins for gy-801 all 5 wires should be connected to board 1.3 ? 5v gnd 3.3v and sda scl ? i think its only one vcc connection.. (5 or 3.3v). which do you recommend ?

ordered first the mainboard from matronics to see if i am able to do a stable setup first -) then i will try to restore a broken mower with working case /motors so i dont have to build everything from scratch is it possible to intercept the signal generated by this base station mower ...

ordered first the mainboard from matronics to see if i am able to do a stable setup first -) then i will try to restore a broken mower with working case /motors so i dont have to build everything from scratch is it possible to intercept the signal generated by this base station mower ...