Suchergebnisse

Hello. I make a loading dock for the mower. I saw that to put the battery in charge the two terminals was in contact with the two screws located above the hood. So I connected P42 to the chassis uprights. When I turn on the mower I have 3V between the 2 screws that attaches the PCB to the frame...

Hi all, My mower is finally operational! I'm very happy. It's not too much the season but it is only part of the discount. I have one last question: I try to move the robot around the perimeter without leaving it. With my phone, in Ardumower I go in "commands" then "auto mode" but the robot...

Hello, I can not find the specifiations of the rain sensor. Can you tell me if it should be connect to the analog pin (A0) or digital pin (D0)? Thank you for your help

Hello, I am looking for the wiring of the push button provided in the starter kit. It is a button with "angel eye" 5 pins (C / NO / NC / + / -). I would like the LED to be on (voltage?) When the mower is on. it's possible? Thank you for your help

Hello, It's a silly question but I did not find an answer... I use the push button to turn on the mower and I am in "test mode" so the emergency stop button is disabled. In "production" mode, how do you turn off the mower? I'm talking about turning off the power, not putting the mower in...

I created this illustration for the cabling of the starter kit. It can be put on the Wiki to help beginners like me

Hallo Ich habe diese Frage bereits im englischen Forum gestellt, aber ich weiß nicht, ob es einen Kontakt zwischen den beiden gibt. Wenn Sie nicht duplizieren müssen, sagen Sie es mir bitte. Hier habe ich ein Problem mit der Verkabelung des Empfängers im Wiki. Ist diese Verkabelung korrekt...

Hello, I don't understand this cabling scheme available on the wiki: Http://wiki.ardumower.de/images/3/3f/Perimeter_v2_receiver_circuit.png Why is there a cable fork GND that starts from the coil, while 2 pins GND are available? Can we just solder the 2 legs of the coil and bring out the GND...

hallo, Ich bin neu im Forum. Ich habe den Kit Arduflower gekauft und beginne mit der Bearbeitung. Leiterplattenschweißungen sind kein Problem, aber ich habe einige Fragen für die Fortsetzung des Projekts 1) Gibt es Bilder (Dateien oder Fotos) von der Verdrahtung zwischen der Platine und den...