Cabling the start push button

[pyriame]

Hello,

I am looking for the wiring of the push button provided in the starter kit. It is a button with "angel eye" 5 pins (C / NO / NC / + / -).

I would like the LED to be on (voltage?) When the mower is on. it's possible?

Thank you for your help

 

[bernard]

I would like the LED to be on (voltage?) When the mower is on. it's possible?

What is the voltage of your led button ?
see Page 9 of kicad schematic certainly you can use P50 .

 

[pyriame]

Good question

In fact it's a 5V LED. So I just need a 5V output on the card as for an independent LED.

I do not find on the map a lot of 5V bonus output (and maybe a resistance ?). I wanted to use the pin matrix (below the outputs P23 and P35) but I do not understand how they work and if it's a good idea.

 

[bernard]

I wanted to use the pin matrix

Yes why not, you can also use the P31 Dropleft connector GND/5V near P20 (If you Don't have a drop sensor).