Suchergebnisse

Hi, Anyone has an idea (if it is possible at all) how to properly connect two mow motors (from the shop) to the PCB 1.3 on 3d printer chassis (aka V2)? Original (V1) chassis has 1 mower motor and it is attached via motor protection circuit to both outputs of MC33926. At the same time it...

First, big thanks to @raess and others for undertaking this. Before I add my experience and thoughts here couple of things I have to mention: - I have "original"/"experimental" chassis from the shop and used the robot for one season already. Had some minor issues and repairs here and there, but...

Hi, Another question on perimeter wire layout itself. I have excluded children playground area similar to the the figure 2 as shown in Wiki http://wiki.ardumower.de/index.php?title=Datei:Perimeter_excluding_objects.png The problem I have is that if mower hits the perimeter wire around...

After assembling perimeter sender I have performed tests in room (5m wire + 2x5Ohm resistors), then have setup trial (250m wire (4Ohm) on the ground + 1x6Ohm resistor) outside. Tests were successful in the fact that perimeter was registered by receiver and robot behaved as expected. During both...

Hi, Got the parts from the shop and about to start assembling perimeter sender. As I'm learning (everything, including soldering on the go), I want to double-check some things before getting into making HW (I'm more software person). According the schema in...