Du verwendest einen veralteten Browser. Es ist möglich, dass diese oder andere Websites nicht korrekt angezeigt werden. Du solltest ein Upgrade durchführen oder einen alternativen Browser verwenden.
Thanks!!
With update the due firmware I have to try. Last time it didn't work. I think because I didn't switch JP8.
I tried PIardu start AREA 2 today. But he jumps back to AREA 1. Is this normal?
If I do this in Piardu test it works.
Hello everybody,
Is there a possibility to create a user and password for MQTT?
I couldn't find this in the config.
I also have other devices that access my MQTT server and require a user and password.
@ jussip
Thanks that was also my first thought.
I checked that.
Bernd is right, I have to recalibrate.
@ Bernd
ping is the ip ping test for me.
I forgot to change the address of the Mqtt broker.
Now that works again.
I use Mobaxterm to check. Here I can see that the camera is not working.
I...
It has nothing to do with my problems, but the PI tries to ping.
Then the Ardumower sreen freezes. (Not the Raspberry Pi)
After a restart it works again until the ping.
Do I have to change anything?
Hello Bernd,
thank you!
I tested the 1.3 firmware today. I was able to adjust it perfectly with your instructions. He mowed the path perfectly for 30 minutes.
and then he started turning to find yaw, over and over again.
I am not sure if I have calibrated the IMU correctly.
And Rand doesn't...
Hi,
I've been following this project for a while and I'm very excited about it.
I use the last firmware from Bernd.
In the Rand the Ardumower works very well.
But in lane I have a problem that I couldn't solve.
After 1 hour he only mowed the strip.
After each calibration, it changes direction...