Hey @ all.
I`m not able to flash the arduino nano with the sender software.
There is no warning message, I can see the activ COM 5 port on the IDE but no reaction during flushing.
I left the nano during the process installed. After connecting the USB cable both green LED are illuminated the yellow is blinking in order with the little red LED installed on the nano.
Warning.png Wichtig: Vergewissere Dich, dass die Pin-Konfiguration des Arduino im benutzten Code (sender.ino) mit Deinem Senderaufbau übereinstimmt!
Can`t understand this instruction. Is there someone outside who can explain.
UWE
I`m not able to flash the arduino nano with the sender software.
There is no warning message, I can see the activ COM 5 port on the IDE but no reaction during flushing.
I left the nano during the process installed. After connecting the USB cable both green LED are illuminated the yellow is blinking in order with the little red LED installed on the nano.
Warning.png Wichtig: Vergewissere Dich, dass die Pin-Konfiguration des Arduino im benutzten Code (sender.ino) mit Deinem Senderaufbau übereinstimmt!
Can`t understand this instruction. Is there someone outside who can explain.
UWE