My Brushless motor driver V1.1 seems to be death after a simple test run at 200 PWM.
What I checked so far....
1. The console gives me a "error: motor mow fault". When I swap the drive with the Left motor-drive. The fault-message changes to "error: motor left fault" ==> So there is a problem with the mower drive
2. Fuse = OK
4. SPI communication is not possible with the Mower-drive
Any ideas?
What I checked so far....
1. The console gives me a "error: motor mow fault". When I swap the drive with the Left motor-drive. The fault-message changes to "error: motor left fault" ==> So there is a problem with the mower drive
2. Fuse = OK
4. SPI communication is not possible with the Mower-drive
Any ideas?