I was trying to get all motors drivers assembled and tested when I noticed that the brushless board gets really hot in one spot.
Even with everything unplugged, just the power wires to the board from the battery, it starts burning instantly.
Is this normal?
I tested it with AT+E and it seemed to work fine, there was a serial warning about too much current, each driver was supposedly drawing 6 amps, though only one was connnected.
Even with everything unplugged, just the power wires to the board from the battery, it starts burning instantly.
Is this normal?
I tested it with AT+E and it seemed to work fine, there was a serial warning about too much current, each driver was supposedly drawing 6 amps, though only one was connnected.
Zuletzt bearbeitet: