3D printer parts questions

[Tna_331]

I am printing a version of the artic hare shown here ...

Ardumower Arctic Hare improvements by PaddyCube

This is a remix of raess fantastic printable chassis for Ardumower DIY Lawn mower. All credits to raess, I just fixed some thinks. Most parts are now printable without support, some will need little support, but much less than original. Also, some parts are more strength, screws, washers and...

www.thingiverse.com

I am confused about how to print a few parts ...
lower body normal for one.

Could someone give me an idea of how they printed this piece?

Thanks!

 

[lichte]

Hi, look at this thread:

Paddy's Ardumower Arctic Hare

Hallo zusammen, nachdem Robin das neue Ardumower Chassis soweit fertig hat, habe ich begonnen, dies nachzubauen. Dabei sind mir einige Dinge aufgefallen, die man verbessern/anpassen kann. Um die von mir vorgenommenen Anpassungen zu dokumentieren, habe ich den Thread eröffnet Alle hier...

forum.ardumower.de

You will need support for this part.

 

[Tna_331]

I laid it on the bottom and added support. I hope it works out ok. Have you built the artichare?

 

[lichte]

Yes I had built this chasis. It is looking really nice, but.......it took a lot of printing time and filament.....and work hours to put everything together.
Good luck and hopefully you printer is has not to many failures.

 

[Tna_331]

Thanks, I hope so too. There is a lot of things to print! I wish my printer was just a little bigger then I could print the other one that has fewer pieces.