Aktueller Inhalt von sigismondi

What is the best?? HC5 or HM-10 Bluetooth BLE BT 4.0 CC2541 CC2540 für Arduino iOS Android Low Energy of Marotronics?? The HM-10 can take place of HC5..it it the same software?? Thanks

Dear All, please anyone could help me to troubleshooting this error..ERR_MOTOR_LEFT I have last code 1.0a4-Azurit 8 of july when in manual mode or automatic, the system ask the left motor to reverse direction, the ERR MOTOR LEFT start to increase the counter.. - test motor in forward...

Dear All, I have PCB prototype by Marotronics I connect the robot to the bluetooth (Pfod), but it doesn't reply. I have to connect also to the USB port the arduino MEGA and the system start...after that I can use the pfod to control it..why? Is it some power supply problem to the arduino...

PCB protiotype... help...both voltage and current of the battery doesn't work?? What I must check?? Is there any Jumper needed foe battery sensors? thank you bye

Dear All, I have two question to complete my PCB 0.5 1) Do I understand corretly? If I use ARDUINO DUE ----> Lp0-Lp15 must be open, as they are on PCB. If I use ARDUINO MEGA ----> Lp0-Lp15 must be welded (short-circuit) 2) If I use ARDUINO DUE---> DC/DC 10V (must be used), DC/DC 3V...

Dear All, as I told..I make a test program for Mc33296 Pololu. Simple forward @55pwm, stop, reverse@55pwm, stop. and //void setMC33926(int IN2, int pinPWM, int speed){ // if (speed < 0){ // digitalWrite(IN2, HIGH) ; // analogWrite(pinPWM, 255-((byte)abs(speed))); // } else { //...

Dear All, I use Mc33296 dual motor on wheels. When I start the serial console, the motor connected to M2 channel of MC33296 start immediately to rotate untill ADC calibration is anded. Also the motor on channel M2 fails the motor test, it can rotate to forward for 1/2 speed, but it can't rotate...

Dear All, I'm using the old PCB with MC33296 for motor wheel..I noticed that in the software was something missing to use MC33296...I would like to add the following software part. Could any programmer tell me if it seams ok?..I didn't try yet...DO I need something else in the software? :silly...

like the V0.93?

Does anyone make code software for v0.93 rain sensor?? Could you show me? thank you