In the wiki, there are some different facts to the resistance of the Perimeter wire. First, there is written that the resistance should be between 5 Ohm and 12 Ohm. A little bit later, there is written that the wire should have a resistance, which is bigger than 12 Ohm. Do someone can give me a feedback? How big is correct resistance?
resistance of the wire
- Ersteller Biland
- Erstellt am
Fürst Ruprecht
Well-known member
The resistance depends on your implementation. It should be about 12-15 ohms so that the electronics of the charging station work properly and are not overloaded.
Important: U_out should be 6,5-12V and I_out < 1A so you must adapt the resistance if the wire.
The resistor must have a power of IxIxR -> max 1A x 1A x 12ohm -> 12W
Important: U_out should be 6,5-12V and I_out < 1A so you must adapt the resistance if the wire.
The resistor must have a power of IxIxR -> max 1A x 1A x 12ohm -> 12W