Ich habe das 1.4 Board. Habe ich einen INA169?

[jschwalbe]

Ich kann mich nicht erinnern, einen INA169 gelötet zu haben. Habe ich einen? Sollte ich?

 

[Svolo]

Hallo jschwalbe,
bei dem 1.4er Board ist der INA Stromsensor bereits fest auf der Platine aufgelötet.

Hello @jschwalbe,
at the PCB 1.4 the INA is directly soldered to the board.



Gruß / regards
Sven

 

[jschwalbe]

Thank you so much! I searched the pdf for “INA” -
No idea why it didn’t take me right there. Sorry for the trouble. I’m trying to figure out why my board keeps telling me low voltage.

 

[Xtasy]

Thank you so much! I searched the pdf for “INA” -
No idea why it didn’t take me right there. Sorry for the trouble. I’m trying to figure out why my board keeps telling me low voltage.

Did you check if the 5V are correct? What voltage is your battery / what is the cutoff voltage in your FW?

 

[jschwalbe]

Did you check if the 5V are correct? What voltage is your battery / what is the cutoff voltage in your FW?

Battery voltage is 28V. Cutoff is much lower than that. I think 19-22ish. The console reads "0.00V".
Can you please explain what you mean by "5V are correct"?
Thank you!

 

[Xtasy]

Battery voltage is 28V. Cutoff is much lower than that. I think 19-22ish. The console reads "0.00V".
Can you please explain what you mean by "5V are correct"?
Thank you!

You have a little voltage regulator on your board which needs to put out 5v. There is a little screw to adjust it

 

[jschwalbe]

Do you mean 9V?