DHT22 Temperature wiring PCB1.3

[bernard]

Here the wiring to add a DHT22 on the PCB1.3

CAUTION THE 10K RESISTOR IS NOT NEEDED (SEE Uwe POST LATER)

 

[kurzschuss]

caution
For the DHT22 temperature sensor there is a resistor already on the board.
The connection for the sensor is P35
A 10K Ohm resistor is already present on the board (R39).
The power supply for the sensor is supplied via IORF

Gruß
Uwe

 

[bernard]

Hi Uwe.
Thanks for the info.I 'am going to see it on the Plan.

But it's work perfecly with the 2 resistors in parallel (5K).On the net i read that the resistor can be between 4.7K or 10K.

I am going to remove it .

Again Thanks.